記住我
The aim of this study was to examine the best electrode design for the electrocoagulation process with the best removal performance, reduced passivation on the electrode surface, and lower energy consumption requirements for removing Chromium (Cr) and Lead (Pb) from leather tannery effluent. Three different electrodes were compared: non-rotating disk electrode (NRDE), rotating disk electrode (RDE) and rotating disk mesh electrode (RDME). All electrodes were used to observe a reduction in passivation on the electrode surface and its effects on the removal performance of Cr and Pb. The material used for the electrodes was iron. The maximum removal efficiency obtained was Cr = 87.9% and Pb = 97.5% under the following operating conditions: pH = 7, treatment time = 90 min, current density = 6.57 mA/cm², and RPM = 80. The results show that the electrical energy requirement for treating chromium and lead using RDME was 4.5 kWh/m³, which was found to be lower than the energy requirement observed in various other studies for treating tannery effluent. According to the results, RDME shows the highest removal performance with lower specific energy consumption compared to NRDE and RDE. RDME can be efficiently employed at a larger scale for treating leather tannery effluent.
Section
Research Articles
This work is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License.
Submission of a manuscript to the Journal will be taken to imply that:
The work is original and has not been previously published (except in the form of an abstract or a part of a published lecture, review or thesis). It is not being considered for publication elsewhere, and If accepted for publication, it will NOT be published commercially elsewhere in the same form, in any language, without the consent of Editor or Publisher.
留言 (0)