Reynolds O. On the theory of lubrication and its application to Mr Beauchamp Tower’s experiments including an experimental determination of the viscosity of olive oil. Proc Royal Soc 40: 191–203 (1886)

Article  MATH  Google Scholar 

Grubin A N. In Fundamentals of the Hydrodynamic Theory of Lubrication of Heavily Loaded Cylindrical Surfaces. Ketova F, Ed. Moscow: Central Scientific Research Institute for Technology and Mechanical Engineering, 1949: Book 30: 115–166.

Hamrock B J, Dowson D. Isothermal elastohydrodynamic lubrication of point contacts I—Theoretical formulation. J Lubr Technol 98(2): 223–228 (1975)

Article  Google Scholar 

Hamrock B J, Dowson D. Isothermal elastohydrodynamic lubrication of point contacts: Part III—Fully flooded results. J Lubr Technol 99(2): 264–275 (1976)

Article  Google Scholar 

Hamrock B J, Dowson D. Isothermal elastohydrodynamic lubrication of point contacts: Part II—Ellipticity parameter results. J Tribol 98(3): 375–381 (1976)

Google Scholar 

Hamrock B J, Dowson D. Isothermal elastohydrodynamic lubrication of point contacts: Part IV—Starvation results. J Tribol 99(1): 15–23 (1977)

Google Scholar 

Guangteng G, Cann P M, Spikes H A. A study of parched lubrication. Wear 153(1): 91–105 (1992)

Article  Google Scholar 

Cann P M. Starvation and reflow in a grease-lubricated elastohydrodynamic contact. ASLE Trans 39(3): 698–704 (1996)

Google Scholar 

Cann P M E, Chevalier F, Lubrecht A A. Track depletion and replenishment in a grease lubricated point contact: A quantitative analysis. Tribol 32: 405–413 (1997)

Google Scholar 

Chevalier F, Lubrecht A A, Cann P M E, Dalmaz G. The evolution of lubricant film defects in the starved regime. Tribol 34(98): 233–242 (1998)

Google Scholar 

Damiens B, Lubrecht A A, Cann P M E. Lubrication regimes in rolling element bearings. Tribol 39(01): 295–301 (2001)

Google Scholar 

Cann P M E, Damiens B, Lubrecht A A. The transition between fully flooded and starved regimes in EHL. Tribol Int 37(10): 859–864 (2004)

Article  Google Scholar 

Qian S, Guo D, Liu S, Lu X, Experimental investigation of lubricant flow properties under micro oil supply condition. J Tribol 134(4): 041501 (2012)

Article  Google Scholar 

Huang L, Guo D, Wen S, Wan G T Y. Effects of slide/roll ratio on the behaviours of grease reservoir and film thickness of point contact. Tribol Lett 54(3): 263–271 (2014)

Article  Google Scholar 

Liang H, Guo D, Ma L, Luo J. Experimental investigation of centrifugal effects on lubricant replenishment in the starved regime at high speeds. Tribol Lett 59(1): 1–9 (2015)

Article  Google Scholar 

Huang L, Guo D, Wen S Z. Film thickness decay and replenishment in point contact lubricated with different greases: A study into oil bleeding and the evolution of lubricant reservoir. Tribol Int 93: 620–627 (2016)

Article  Google Scholar 

Pemberton J, Cameron A. A mechanism of fluid replenishment in elastohydrodynamic contacts. Wear 37(1): 185–190 (1976)

Article  Google Scholar 

Venner C H, van Zoelen M T, Lugt P M. Thin layer flow and film decay modeling for grease lubricated rolling bearings. Tribol Int 47: 175–187 (2012)

Article  Google Scholar 

Hu J, Wu W, Wu M, Yuan S. Numerical investigation of the air-oil two-phase flow inside an oil-jet lubricated ball bearing. Int J Heat Mass Tran 68: 85–93 (2014)

Article  Google Scholar 

Cameron A, Evans D, Wedeven L D. Optical analysis of ball bearing starvation. J Tribol 93(3): 349 (1970)

Google Scholar 

van Emden E, Venner C H, Morales-Espejel G E. Aspects of flow and cavitation around an EHL contact. Tribol Int 95(Suppl 1): 435–448 (2016)

Article  Google Scholar 

Košťál D, Nečas D, Šperka P, Svoboda P, Křupka I, Hartl M. Lubricant rupture ratio at elastohydrodynamically lubricated contact outlet. Tribol Lett 59(3): 39 (2015)

Article  Google Scholar 

Košťál D, Šperka P, Svoboda P, Křupka I, Hartl M. Influence of lubricant inlet film thickness on elastohydrodynamically lubricated contact starvation. J Tribol 139(5): 051503 (2017)

Article  Google Scholar 

Li X M, Guo F, Wong P L, Zhao Y. Regulation of lubricant supply by wettability gradient in rolling EHL contacts. Tribol Int 120: 565–574 (2018)

Article  Google Scholar 

Chan R T P, Martinez-Botas R F, Gohar R. Isoviscous flow past a rigid sphere partially immersed in a thin oil film. Lubr Sci 19(3): 197–212 (2007)

Article  Google Scholar 

Bruyere V, Fillot N, Morales-Espejel G E, Vergne P. A two-phase flow approach for the outlet of lubricated line contacts. J Tribol 134(4): 041503 (2012)

Article  Google Scholar 

Fischer D, Goeldel S V, Jacobs G, Stratmann A. Numerical investigation of effects on replenishment in rolling point contacts using CFD simulations. Tribol Int 157: 106858 (2021)

Article  Google Scholar 

Yin J, Eissa K I, Gohar R, Cann P M E. Rebounding lubricant layers. Lubr Sci 12(1): 1–30 (1999)

Article  Google Scholar 

Gershuni L, Larson M G, Lugt P M. Lubricant replenishment in rolling bearing contacts. Tribol Trans 51(5): 643–651 (2008)

Article  Google Scholar 

van Zoelen M T, Venner C H, Lugt P M. Free surface thin layer flow on bearing raceways. J Tribol 130(2): 021802 (2008)

Article  Google Scholar 

van Zoelen M T, Venner C H, Lugt P M. The prediction of contact pressure-induced film thickness decay in starved lubricated rolling bearings. Tribol Trans 53(6): 831–841 (2010)

Article  Google Scholar 

van Zoelen M T, Venner C H, Lugt P M. Free surface thin layer flow in bearings induced by centrifugal effects. Tribol Trans 53(3): 297–307 (2010)

Article  Google Scholar 

Wu W, Hu J, Yuan S, Hu C. Numerical and experimental investigation of the stratified air-oil flow inside ball bearings. Int J Heat Mass Tran 103: 619–626 (2016)

Article  Google Scholar 

Wu W, Hu C, Hu J, Yuan S. Jet cooling for rolling bearings: Flow visualization and temperature distribution. Appl Therm Eng 105: 217–224 (2016)

Article  Google Scholar 

Adeniyi A A, Morvan H P, Simmons K A. A Multiphase Computational Study of Oil-Air Flow Within the Bearing Sector of Aeroengines. In Proceedings of the ASME Turbo Expo 2015: Turbine Technical Conference and Exposition. Volume 5C: Heat Transfer, Montreal, Canada, 2015: V05CT15A024.

Adeniyi A A, Morvan H, Simmons K. A computational fluid dynamics simulation of oil-air flow between the cage and inner race of an aero-engine bearing. J Eng Gas Turb Power 139(1): 012506 (2016)

Article  Google Scholar 

Yan K, Zhang J, Hong J, Wang Y, Zhu Y. Structural optimization of lubrication device for high speed angular contact ball bearing based on internal fluid flow analysis. Int J Heat Mass Tran 95: 540–550 (2016)

Article  Google Scholar 

Yan K, Wang Y, Zhu Y, Hong J. Investigation on the effect of sealing condition on the internal flow pattern of high-speed ball bearing. Tribol Int 105: 85–93 (2017)

Article  Google Scholar 

Yan K, Dong L, Zheng J, Li B, Wang D, Sun Y. Flow performance analysis of different air supply methods for high speed and low friction ball bearing. Tribol Int 121: 94–107 (2018)

Article  Google Scholar 

Ge L, Wang C, Yan K, Zhu Y, Hong J. Design of groove structures for bearing lubrication enhancement based on the flow mechanism analysis. Tribol Int 158(2): 106950 (2021)

Article  Google Scholar 

Ge L, Yan K, Wang C, Zhu Y, Hong J. A novel method for bearing lubrication enhancement via the inner ring groove structure. J Phys: Conf Ser 1820(1): 012092 (2021)

Google Scholar 

Liang H, Zhang Y, Wang W Z. Influence of the cage on the migration and distribution of lubricating oil inside a ball bearing. Friction 10(7): 1035–1045 (2022)

Article  Google Scholar 

Hirt C W, Nichols B D. Volume of fluid (VOF) method for the dynamics of free boundaries. J Comput Phys 39(1): 201–225 (1981)

Article  MATH  Google Scholar 

Brackbill J U, Kothe D B, Zemach C. A continuum method for modeling surface tension. J Comput Phys 100(2): 335–354 (1992)

Article  MathSciNet  MATH  Google Scholar 

ANSYS. ANSYS Fluent Theory Guide. ANSYS (USA): ANSYS Inc., 2016.

Chen H, Wang W, Liang H, Zhao Z. Patterns of interfacial flow around a lubricated rolling point contact region. Phys Fluids 33(10): 102118 (2021)

Article  Google Scholar